RIDGID TS3660 Operator's Manual page 20

ASSEMBLY
TO INSTALL THE HERC-U-LIFT™ MOBILE
BASE TO THE LEG STAND
See Figures 14 - 16.
WARNING:
Do not lift the saw without help. Hold it close to
your body. Keep your knees bent and lift with
your legs, not your back. Ignoring these precau-
tions can result in back injury.
 Locate the following parts:
2 rear tubes
1 center brace
1 unlock pedal assembly
2 front tubes
1 tube support
1 U-bolt tube
1 U-bolt
4 swivel casters
4 screws (1/4-20 x 1-5/8 in. with washer)
8 screws (1/4-20 x 1/2 in. with washer)
4 screws (1/4-20 x 1-1/2 in.)
4 screws (1/4-20 x 2 in. with washer)
4 flat washers
4 flange nuts (5/16-18)
4 flange nuts (7/16-14)
20 lock nuts (1/4-20)
To assemble the lower section:
 Thread flange nuts (5/16-18) onto the U-bolt as far as
they will go.
 Slide the U-bolt into the center holes on the U-bolt tube
and secure in place using flange hex nuts (5/16-18).
 Place the front tube on top of the U-bolt tube. Insert
screws (1/4-20 x 2 in. with washer) into the aligned holes
on both the tube and support. Finger tighten using lock
nuts (1/4-20).
NOTE: The small holes on the front tube must be facing up.
 Place the tube support under the front tube and secure
in place with the screws (1/4-20 x 2 in. with washer) and
lock nuts (1/4-20) from blister pack.
 Repeat for other side of the lower section.
 Place the caster up through the hole in the lower section
and secure in place using flanged nuts (7/16-14). Repeat
for other side.
To assemble the upper section:
 Place the unlock pedal assembly on top of the rear tubes.
Secure in place using the screws (1/4-20 x 1-1/2 in.) and
lock nuts (1/4-20).
 Place the caster up through the hole in the center brace
then through the rear tube and secure in place using
flanged nuts (7/16-14). Repeat for other side.
TUBE
SCREW
SUPPORT
(1/4-20 x 2 in.)
HEX
NUT
CASTER
UNLOCK PEDAL
ASSEMBLY
(1/4-20 x 1- 1/2 in.)
SMALL HOLE
ON TOP
FLAT WASHER
SCREW
(1/4-20 x 1/2 in.)
20
LOWER SECTION
U-BOLT
U-BOLT
TUBE
SMALL HOLE
ON TOP
UPPER SECTION
REAR TUBE
FLANGED
NUT
CENTER
(7/16-14)
BRACE
CASTER
SCREW
SCREW
(1/4-20 x 1- 5/8 in.)
SCREW
(1/4-20 x 1/2 in.)
LEG
BRACKET
FLANGED
NUT
(7/16-14)
FRONT
TUBE
SMALL HOLE
ON TOP
Fig. 14
Fig. 15