HP J9827A Installation Manual page 19

The default port configurations for connection parameters are:
Ports Enabled: Yes
Mode:
◦
10/100/1000-T v2zl Modules: Auto — The port auto negotiates speed (10, 100 or 1000
Mbps), communication mode (half or full duplex), and MDI or MDI-X port operation.
NOTE: If you configure the port to one of the fixed 100 Mbps modes, the port will then operate
only as an MDI-X port.
Gigabit-SX, Gigabit-LX, and Gigabit-LH ports in SFP v2 zl Module: Auto — The port always
operates at 1000 Mbps and full duplex. The setting is Auto for best link establishment with other
devices.
Flow Control: Disabled
Advanced features — Spanning Tree, Trunking, Meshing, VLANs, IGMP, LACP, Routing,
Class of Service, Security, and so forth: all Disabled
If necessary, configure the port(s) in the module by using the switch console or the web browser
interface. For more information, see the Management and Configuration Guide for your switch
at www.hpe.com/networking/support, and the online Help provided in the console and web
browser interfaces. If the default port configuration listed above is acceptable for your network,
then skip this process.
Default Port Configuration 19