The V2 Zl Modules Have The Following Features - HP J9827A Installation Manual

Hp switch zl2 modules
Table of Contents

Advertisement

The v2 zl Modules have the following features:

All v2 zl modules share the following features:
auto-enabled ports—the ports are all configured to be ready for network operation as
soon as a viable network cable is connected
auto-configuration—a default configuration is applied to the module when the switch is
powered on and the module passes self test; this default configuration works well for
most network installations
LEDs that provide information for each port on the link status, network activity, connection
bandwidth (speed), communication mode (half or full duplex)
"hot swap modules" operation—you can add a module or replace a module without
having to shut down the switch
"hot swap SFPs" operation—you can add, replace, or change the type of any of the
SFPs that you use without having to first remove the module, and without having to shut
down the switch
the RJ-45 ports on all modules have the HPE Auto-MDIX and the IEEE 802.3ab Auto
MDI/MDI-X feature. These features operate the same way and allow you to use either
straight-through or crossover twisted-pair cables for all the twisted-pair network
connections. (See the note on "Automatic Cable Sensing" in
on Twisted-Pair
Ports.)
Automatic Cable Sensing
The v2 zl Modules have the following features:
11

Advertisement

Table of Contents
loading

Table of Contents