Installation In Conjunction With A Rosemount 333 Hart Tri-Loopt Hart-To-Analog Signal Converter - Fisher FIELDVUE DLC3010 Instruction Manual

Instruction Manual
D102748X012
Installation in Conjunction with a Rosemount 333 HART Tri‐Loop
HART‐to‐Analog Signal Converter
Use the DLC3010 digital level controller in operation with a Rosemount 333 HART Tri-Loop HART‐to‐Analog Signal
Converter to acquire an independent 4‐20 mA analog output signal for the process variable, % range, electronics
temperature, and process temperature. The Tri‐Loop divides the digital signal and outputs any or all of these variables
into as many as three separate 4‐20 mA analog channels.
Refer to figure 2‐13 for basic installation information. Refer to the
Converter Product Manual
Figure 2‐13. HART Tri‐Loop Installation Flowchart
START HERE
Unpack the
HART Tri‐Loop
Review the
HART Tri‐Loop
Product Manual
Digital level
No
controller
Installed?
Yes
Set the digital
level controller
Burst Option
Set the digital
level controller
Burst Mode
E0365
for complete installation information.
Install the HART
Tri‐Loop. See
HART Tri‐Loop
Product Manual
Mount the HART
Tri‐Loop to the
Wire the digital
Install the digital
level controller to
level controller.
the HART Tri‐Loop.
Install Channel 1
wires from HART
Tri‐Loop to the
control room.
(Optional)
Install Channel
2 and3 wires from
HART Tri‐Loop to
the control room.
333 HART Tri‐Loop HART‐to‐Analog Signal
Configure the HART
Tri‐Loop to receive
digital level controller
burst commands
DIN rail.
Check
No
Pass system
troubleshooting
test?
procedures in HART
Tri‐Loop product
manual.
Yes
DONE
Installation
October 2014
27