Kenwood TK-7360 Instruction Manual page 14

n Storing an Autodial Entry
1 Press the key programmed as Autodial Programming.
2 Press /
or <B/C> to select a memory locaton number.
3 Press S to enter a name for the lst number.
4 Press /
5 Press C> to accept the entered dgt and move the cursor to the rght.
• Press A or # to delete an ncorrect dgt. Press and hold A or # to delete all
dgts.
6 Repeat steps 4 and 5 to enter the entre name.
7 Press S to accept the name and enter a number.
8 Press /
• You can also enter dgts drectly usng the keypad.
9 Press C> to accept the entered dgt and move the cursor to the rght.
• Press A or # to delete an ncorrect dgt. Press and hold A or # to delete all
dgts.
10 Repeat steps 8 and 9 to enter the entre number.
11 Press S to accept the number and store the entry.
n Removing an Autodial Entry
1 Press the key programmed as Autodial Programming.
2 Press /
or <B/C> to select a memory locaton number.
3 Press A or #.
• "DELETE" appears on the dsplay.
• Addtonally, you can press and hold A or # to delete all entres.
4 Press S or
R
EDIALING
1 Press the key programmed as Autodial.
2 Press , then 0.
• If there s no data n the redal memory, an error tone wll sound.
3 Press the PTT swtch to make the call.
S
TUN
Ths functon s used when a transcever s stolen or lost. When the transcever
receves a call contanng a stun code, the transcever becomes dsabled. The
stun code s cancelled when the transcever receves a call wth a revve code.
• "STUN" appears on the dsplay whle the transcever s stunned.
(if the key assignment list selection is configured as "Enabled")
to select a dgt.
to select a dgt.
(if the key assignment list selection is configured as "Enabled")
to confirm the deletion.
9