Chapter 4 - Final Checkout; Product-Specific Safety Notices; General Safety - Geist RCX Instruction Manual

Chapter 4 - Final Checkout

Product-Specific Safety Notices

The specific procedural safety precautions relating to this product are stated
below.

General Safety

Safety is a serious matter and all precautions should to taken to guarantee a
safe work and operational environment. General safety precautions must be
observed during all aspects of operation, service, and repair of equipment
described in this document. Failure to comply with the safety warnings,
procedures and guidelines as presented in this document is in violation of the
safety standards of design, manufacture, and intended use of this equipment.
You are responsible for following the safety guidelines and warnings presented
in this document for this equipment. Individuals using or maintaining Geist
product(s) are expected to follow all the noted warnings and safety precautions
necessary for safe operation of the equipment in your environment. Geist
assumes no liability for failure to comply with these requirements.
Live Circuits Safety
Operating personnel must:
· Not remove equipment covers. Only Geist Authorized Service Personnel or
other qualified maintenance personnel may remove equipment covers for
internal sub-assembly, or component replacement, or any internal adjustment.
· Not replace any equipment component with power applied to the line cord.
Under certain conditions, dangerous voltages may exist even with the input
power cable disconnected. Any exceptions for 'Hot-Swap' modules will be
specifically noted in this product document.
GM1196 R-Series v5 Instruction Manual
DANGER
HAZARDOUS VOLTAGE, CURRENT, AND ENERGY LEVELS
ARE PRESENT IN THIS PRODUCT. POWER SWITCHED
CIRCUITS CAN HAVE HAZARDOUS VOLTAGES PRESENT
EVEN WHEN THE SWITCH IS IN THE OFF POSITION. DO
NOT OPERATE THE PRODUCT WITH ANY COVER PLATE
REMOVED. ALWAYS MAKE SURE THAT PRODUCT IS
FULLY ENCLOSED PRIOR TO USE.
Chapter 3 - Setup
© 2018 Geist
79