Geist RCX Instruction Manual page 65

Target email addresses can be configured as follows:
Legend of icons/buttons:
1. Add new target email address.
2. Modify existing target email address.
3. Delete existing target email address.
4. Send test email.
To send emails, the unit must be configured to access the mail server, as follows:
· SMTP Server: The name or IP address of a suitable SMTP or ESMTP server.
· Port: The TCP port which the SMTP Server uses to provide mail services. Typical
values would be port 25 for an unencrypted connection, or 465 and 587 for a TLS/SSL-
encrypted connection, but these may vary depending on the mail server's configuration.
· Enable SSL: If Enabled, the unit will attempt to connect to the server using a fully-
encrypted TLS/SSL connection. When this setting is enabled only fully-encrypted
GM1196 R-Series v5 Instruction Manual
Figure 3-37 Email Configuration Page
Figure 3-38 Email Target Address Page
Chapter 3 - Setup
© 2018 Geist
65