Geist RCX Instruction Manual page 67

Chapter 3 - Setup 67
alarm traps can be sent to up to two IP addresses.
Figure 3-40 SNMP Configuration Page
The SNMP-V1/V2c and SNMP-V3 Service can be enabled or disabled independently as
desired. The service will normally listen for data-read requests (a.k.a. "GET requests") on
Port 161, which is the usual default for SNMP services; this can also be changed if
desired.
The Management Information Base (MIB) can be downloaded from the unit, if needed, via
the MIB link at the top of the web page. Clicking this link will download a .ZIP archive
containing both the MIB file itself, and a CSV-formatted spreadsheet describing the
available OIDs in a human-readable form to assist you in setting up your SNMP manager
to read data from the unit.
Figure 3-41 SNMP Users Configuration Page
The Users section allows you to configure the various Read, Write, and Trap communities
for SNMP services. You can also configure the authentication types and encryption
methods used for the SNMP v3 if desired. Click the Modify icon to change settings.
Figure 3-42 SNMP Traps Configuration Page
GM1196 R-Series v5 Instruction Manual
© 2018 Geist