Geist RCX Instruction Manual page 30

30 R-Series v5 Instruction Manual
than one TCP/IP entry, as in the example above, the computer may be configured for IPv6
support as well as IPv4; make sure to select the entry for the IPv4 protocol. Write down
the current NIC card settings so you can restore them to normal after you have completed
the setup procedure.
Figure 2-16 Internet Protocol Version 4
Choose the Use the following IP address option, then set IP address to 192.168.123.1
and Subnet Mask to 255.255.255.0. For this initial setup, Default Gateway and the DNS
Server entries can be left blank. Select OK, then OK again to close both the Internet
Protocol Properties and Local Properties windows.
Once the NIC settings are configured properly, you should be able to access the unit by
typing http://192.168.123.123 into the address bar of your web browser. If you are setting
up the unit for the first time, or if the unit has been reset back to factory defaults via the
network-reset button, the unit will require you to create an Admin account and password
before you can proceed.
Once you have created an Admin account and have logged into it, the unit's default
Sensors page should come up by default. Navigate to the System tab, then the Network
GM1196 R-Series v5 Instruction Manual
© 2018 Geist