JVC KD-AV7005 Service Manual page 10

3.1.4 Removing the top drive unit
(See Figs.6 to 9)
• Prior to performing the following procedures, remove the dis-
play unit, detach panel assembly and front panel assembly.
(1) From the both sides of the main body, remove the four
screws B attaching the top drive unit. (See Figs.6 and 7.)
(2) From the rear side of the main body, remove the three
screws C attaching the top drive unit. (See Fig.8.)
(3) Remove the top drive unit from the main body and turn it
inside out. (See Fig.9.)
(4) Remove the two screws C attaching the F.P.C. guide on
the display drive unit. (See Fig.9.)
(5) Release the lock of the connector
nism board and disconnect the flexible wire. (See Fig.9.)
(6) Remove the two screws D attaching the CN guide. (See
Fig.9.)
(7) Remove the three screws E attaching the PWB base. (See
Fig.9.)
(8) Remove the screw F attaching the connect board. (See
Fig.9.)
(9) Take out the connect board in the direction of the arrow.
(See Fig.9.)
(10) Release the lock of the connector
board and disconnect the flexible wire. (See Fig.9.)
B
1-10 (No.MA101)
CN301 on the mecha-
CN391 on the connect
Top drive unit
Fig.6
Top drive unit
B
Fig.7
Top drive unit
B
Fig.8
Lock
Top drive unit
F.P.C.guide
C
D
E
CN guide
PWB base
Lock
Fig.9
CN301
Motor board
Display drive unit
C
E
F
CN391
Connect board