JVC KD-AV7005 Service Manual page 27

3.4.6 Removing the front unit
(See Figs.10 to 12)
• Remove the top cover and the mechanism section.
(1) Disconnect the flexible wire from connector
front end board at the bottom of the body. (See Fig.10.)
(2) Remove the screw E attaching the front unit on the top of
the body. (See Figs.11 and 12.)
(3) Move the front unit toward the front to release joint h, and
release two joints i and j on the right side of the chassis
base assembly. Then remove the front unit upward. (See
Figs.11 and 12.)
(4) Remove the two screws F attaching the switch board. (See
Fig.12.)
Reference:
You can remove the switch board only without removing the
front unit.
Caution:
When reassembling, attach the flexible wire extending from
the switch board using the double tape. (See Figs.10 and 12.)
Front end board
Double tape
CN202
CN202
Flexible wire
Fig.10
on the
Double tape
j
i
Chassis base assembly
E
Front unit
h
Fig.11
F
Switch board
E
Front unit
h
Fig.12
(No.MA101)1-27