Invertek Drives OPT-2-ETHEG-IN Installation And Operating Instructions Manual page 16

6.7.3. Network Settings
The present network settings for the interface are displayed. This data may be changed by the user.
'Configured' indicated the values currently stored within the module.
'Working Values' indicate the values currently in use (if not yet edited), or the values to be applied. To commit values press 'Set'
Module will reboot if data is valid, otherwise an error status will be displayed:
Status
State
'Data Submitted...'
'Data Read/Write Error'
'Resource Busy'
'Invalid request - Data Validation Error'
'Data Accepted - Restarting Module at new
IP Address...'
6.7.4. Drive Identity
Data is read from the Drive.
If the Drive does not support this functionality then the following data is required:

Vendor Name: 'Unknown Modbus Device'

Product Code: Empty

Version Number: Empty
16
Optidrive ODP-2ETHEG-IN User Guide Revisions 1.00
Indication
Data has been submitted to OPT-2-ETHEG-IN, awaiting reply
An error occurred, data was not stored
Another operation was accessing the required data for example a
Ethernet/IP Class 0xF5 service
One or more data value were invalid
Data accepted and stored
www.invertekdrives.com