Yamaha TT250RA Owner's Manual page 72

PERIODIC MAINTENANCE AND ADJUSTMENT
according to the procedure on
page 7-32.
4. Pull the wheel axle out, and then
remove the wheel. NOTICE: Do
1 not apply the brake after the
wheel has been removed to-
gether with the brake disc, oth-
2
erwise the brake pads will be
forced shut.
[ECA11071]
3
To install the front wheel
4
1. Install the speedometer gear unit
into the wheel hub so that the pro-
5
jections mesh with the slots.
6
7
8
9
1. Speedometer gear unit
2. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
1
EAU24950
1
1. Retainer
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the wheel axle to the spec-
ified torque.
Tightening torque:
Wheel axle:
58 Nm (5.8 m·kgf, 42 ft·lbf)
6. Tighten the axle holder nuts to the
1. Upper nut
2. Lower nut
3. Gap
7-33
specified tightening torque. Tight-
en the upper nuts first and then
lower ones. When tightened in this
sequence, there should be a gap
formed at the bottom of the axle
holder.
1
Tightening torque:
Axle holder nut:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
7. After tightening the axle holder
nuts, push down hard on the han-
dlebars several times while apply-
ing the front brake to check if the
front fork compresses and re-
2
3