Yamaha TT250RA Owner's Manual page 50

PERIODIC MAINTENANCE AND ADJUSTMENT
2
1
1
2
3
1. Oil filter element
2. O-ring
4
7. Check the O-rings for damage and
replace them if necessary.
5
8. Clean the oil filter element with sol-
vent, and then install it.
6
TIP
Check the oil filter element for damage
7
and replace it if necessary.
9. Install the oil filter element cover by
8
installing the bolts, then tightening
them to the specified torque.
9
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Make sure that the O-rings are properly
seated.
10. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
11. Install the engine oil filter element
drain bolt, and then tighten the bolt
to the specified torque.
Tightening torque:
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
12. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the engine
oil filler bolt.
7-11
Recommended oil:
See page 9-1.
Oil quantity:
Without oil filter element replace-
ment:
1.10 L (1.16 US qt, 0.97 Imp.qt)
With oil filter element replacement:
1.20 L (1.27 US qt, 1.06 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
13. Start the engine, and then let it idle
ECA11620