Engine Oil And Oil Filter Element - Yamaha TT250RA Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
it if necessary.
Specified spark plug:
NGK/CR9E
DENSO/U27ESR-N
1
3. Measure the spark plug gap with a
wire thickness gauge and, if nec-
2
essary, adjust the gap to specifica-
tion.
3
4
5
1
6
7
1. Spark plug gap
8
Spark plug gap:
0.7–0.8 mm (0.028–0.031 in)
9
To install the spark plug
1. Clean the surface of the spark plug
gasket and its mating surface, and
then wipe off any grime from the
spark plug threads.
2. Install the spark plug with the
spark plug wrench, and then tight-
en it to the specified torque.
Tightening torque:
Spark plug:
13 Nm (1.3 m·kgf, 9.4 ft·lbf)
TIP
If a torque wrench is not available when
installing a spark plug, a good estimate
of the correct torque is 1/4–1/2 turn
past finger tight. However, the spark
plug should be tightened to the speci-
fied torque as soon as possible.
3. Install the spark plug cap.
7-9
Engine oil and oil filter
element
The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil filter ele-
ment cleaned at the intervals specified
in the General maintenance and lubri-
cation chart.
To check the engine oil level
1. Place the vehicle on a level sur-
face and hold it in an upright posi-
tion. A slight tilt to the side can
result in a false reading.
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Wait a few minutes until the oil set-
tles, and then check the oil level
through the check window located
at the bottom-right side of the
crankcase.
TIP
The engine oil should be between the
minimum and maximum level marks.
EAU50260