Table of Contents
Advertisement
|
|
|
|
|
|
|
102
InfoPrint XT Guide
Note: The xspcrmi conversion parameter does not control how InfoPrint
XT interprets spacing characters in Xerox fonts that you have
previously loaded with the pdxtloadres command. If you specify
xspcrmi=yes and the job does not contain FILE DJDE commands,
InfoPrint XT does not generate RMI structured fields for any of the
fonts the job uses. In this case, reload the fonts that the job requires
with the pdxtloadres command and use the -b option.
[xstaplemax=n]
Specifies the maximum number of sheets that accumulate before a staple
action occurs. You can specify a value from 1 through 32767. This matches
the values that Xerox printers support. However, Xerox printers do not
staple more than 102 sheets at a time. InfoPrint XT issues a warning
message for each sheet, over 102 sheets, that accumulates for a single
stapling action.
Notes:
1. The printer model that you are using determines the number of sheets
that you can staple at one time. For detailed information, see the
documentation for the printer.
2. If you do not specify the xstaplemax conversion parameter, InfoPrint
XT honors the NTO1 limits that the JDEs for the job specify.
[xstapleorient=yes | no]
Specifies whether InfoPrint XT honors the orientation of the first page of a
report when it determines the corner in which to staple. The default is that
InfoPrint XT always staples in the upper left corner of the pages, as you
look at them in the portrait orientation. If you specify xstapleorient=yes,
InfoPrint XT detects reports whose first pages are in the landscape
orientation. It staples these in the lower-left portrait corner. This
corresponds to the upper-left landscape corner.
[xstaplesysgen=nto1 | 1ton]
Specifies whether the default printing order that was specified to the Xerox
printer at SYSGEN time was 1TON or NTO1. This determines whether the
Xerox printer delivers the printed output starting with the first page of the
job or with the last. If you use the default xstaplesysgen value of 1ton, the
starting JDL and JDE pair for the job must include:
v STAPLE=YES
v NTO1=YES or NTO1=n
v FACEUP=YES
If these values are present in the starting JDL and JDE pair, InfoPrint XT
includes stapling commands in the AFP output that it generates. If the
values are not present, no stapling occurs. This is true even if subsequent
JDL and JDE pairs in the job specify stapling.
If you specify xstaplesysgen=nto1 and subsequent JDL and JDE pairs in
the job specify stapling, InfoPrint XT includes stapling commands in the
AFP regardless of whether the starting JDL and JDE pair specifies stapling.
[xtrblanks= no | yes]
Specifies whether InfoPrint XT removes the trailing blanks on each line of
the input data stream. If you do not specify this parameter, InfoPrint XT
does not remove the trailing blanks.
[xzctrace=yes | no]
Captures trace information that a technical support representative can use
Advertisement
Table of Contents
