Table of Contents
Advertisement
Fixed connection
Fit the power line with an omnipolar circuit
breaker in compliance with installation
regulations.
The circuit breaker should be located near
the appliance and in an easily reachable
position.
Connection with plug and socket
Make sure that the plug and socket are of
the same type.
Avoid using adapters and shunts as these
could cause overheating and a risk of
burns.
Cable replacement
Power voltage
Danger of electrocution
• Disconnect the main power supply.
1. Unscrew the rear casing screws and
remove the casing to access the terminal
board.
2. Replace the cable.
3. Make sure that the cables follow the best
route in order to avoid any contact with
the appliance.
Installation
5.2 Positioning
Heavy appliance
Danger of crush injuries
• Position the appliance with the aid of a
second person.
Pressure on the open door
Risk of damages to the appliance
• Never use the open door to lever the
appliance into place when fitting.
• Avoid exerting too much pressure on the
oven door when open.
Heat production during appliance
operation
Risk of fire
• Veneers, adhesives or plastic coatings
on adjacent furniture should be
temperature-resistant (no less than
90°C).
Improper installation
Risk of damage to people
• The appliance support base should not
exceed a height of 160 mm from the
floor.
Levelling
Level the appliance on the ground using the
adjustable feet. The foot has a range of 10
mm.
17
Advertisement
Table of Contents
