Scanning Part Of An Original - Ricoh Type W3600 Scanner Reference

Scanning Part of an Original

This section explains how to set a custom size for scanning an area within an
original.
Important
❒ Depending on the default setting of [Start Position] or [Scan Area], you might
not be able to make settings for [Original Size] before other items. If this is the
case, first make settings for [Start Position] or [Scan Area], and then [Original
Size]. For details about making default settings for [Scan Area] and [Start Posi-
tion], see General Settings Guide.
To scan a section of an original, measure Original Size (X1 and Y1), Start Position
(X2 and Y2), and Scan Area (X3 and Y3) on the surface of the original, and then
enter those values in the same order. Measuring methods differ depending on
the original's orientation and the position it is set in. The following example
show how to measure the size in order to scan the section marked "R". Refer to
the following examples to measure each size correctly.
The procedure below explains for scanning the "R" area of the original.
A
Press [Scan Settings].
B
Press [Scan Size].
C
Press [Custom Size].
Scanning Custom Size Originals
ATG026S
6
115