Enable/Disable Network Protocols - Ricoh AP1400/AP2000 Operating Instructions Manual

PCL, PS, ASCII
1. To access the LPD Printers menu, type 2 and press the ENTER key. For a unit at factory
default, the menu shown below will appear.
The Configuration Utility
Unit Serial no. 991398 v2.1X
LPD Printers
1. Printer 1
2. Banners
Please Enter Selection (? for Help) :
2. To change the set of emulations, type 1 and press the ENTER key. The options shown
below will appear.
The Configuration Utility
Unit Serial no. 991398 v2.18
Printer 1
1. PCL
2. PS
3. ASCII
4. OTHER
Please Enter Selection (? for Help) :
3. To delete an emulation, select the number opposite the language listed. For example,
type 1 and press the ENTER key to delete PCL. Typing 1 again will again select PCL.
4. From the LPD Printers menu, press 2 to toggle Banners between Enabled/Disabled.
7.5.4

Enable/Disable Network Protocols

To enable network protocols, at the Main menu type 3 and press the ENTER key.
You are given the choice of disabling either NetWare or AppleTalk since both network OS's
are enabled by default. For example, to disable Appletalk, type 2 and press the ENTER key.
Any
PCL OTHER
<CR> changed to
<CR><LF>
no action
Chapter 7 - 19