Left Handlebar Switches; Starter Button - Triumph Tiger XCA Owner's Handbook Manual

Engine Stop Switch
In addition to the ignition switch being
turned to the ON position, the engine
stop switch must be in the RUN position
for the motorcycle to operate.
The engine stop switch is for emergency
use. If an emergency arises which
requires the engine to be stopped, move
the engine stop switch to the STOP
position.
Note:
• Although the engine stop switch
stops the engine, it does not turn
off all the electrical circuits and may
cause difficulty in restarting the
engine due to a discharged battery.
Ordinarily, only the ignition switch
should be used to stop the engine.
Caution
Do not leave the ignition switch in the
ON position unless the engine is
running as this may cause damage to
electrical components
discharge the battery.

Starter Button

The starter button operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the
handlebar.
Note:
• Even if the clutch lever is pulled to
the handlebar, the starter will not
operate if the side stand is down
and a gear is engaged.
Hazard Warning Lights
To turn the hazard warning lights on or
off, press the hazard warning light
button.
The ignition must be switched ON for
the hazard warning lights to function,
but the hazard warning lights remain on
if the ignition is switched OFF until the
hazard warning light button is pressed
again.

Left Handlebar Switches

All Models except Tiger 800 XR
10
and will
ckdf
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
The following sections describe the
handlebar
functions.
General Information
9
8
7
6
Cruise control adjust switch
Daytime Running Lights (DRL) switch
(if equipped)
MODE button
Turn signal switch
Joystick button
Horn button
Heated grips switch
Front fog lights switch (if equipped)
High beam button
Rider and passenger heated seats
switch (if equipped)
buttons
1
2
3
4
5
and switches
81