Advertisement
DD48
Display Units
Series
Dimensions & Panel Cut-out
Binary
Display Unit
End Plate
( DD48-W-
)
7
30
Display units can be combined for up to 16 digits.
When combining 9 to 16 digits, it is recommended to use the long
filter.
Accessories (Optional)
Spacer
DD48-FY1-B (black)
Weight (approx.) 22g
End Plate
DD48-W-
(B: black, Z: beige)
For left
side
Weight (approx.)
20g (pair)
Mounting Clip
DD48-KT1 (black)
Weight (approx.) 7g
22
Decimal
Display Unit Spacer Unit
( DD48-FY1-B )
30
30
7
30N + 14
9.5
Characters can be engraved on
the filter. Used for adjusting the
number of units.
Mounting Method: Same as
display units. Refer to Unit
Combination on page 25.
End plates must be installed at
both ends of the assembly of
the display units.
Mounting Method: Refer to Unit
Combination on page 25.
For right
side
Used to fasten the display units
to the panel when mounting four
units or more.
Mounting Method: Refer to
Panel Mounting on page 25.
Panel Thickness: 0.8 to 4
5
74
(Panel Cut-out)
30N + 9
+1
-0
Note: The panel cut-out width shown above is the minimum length
required. When mounting many display units, determine the
panel cut-out width to fit the actual size.
30
5
7
7
(For left side) (For right side)
6
All dimensions in mm.
Note: When mounting more
than 16 units
16 min.
N : No. of digits (N ≤ 16)
74
5
64
60
8
Advertisement
