PERIODIC MAINTENANCE AND MINOR REPAIR
13. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
1
leaking, immediately turn the
engine off and check for the
2
cause.
14. Turn the engine off, and then
3
check the oil level and correct it if
necessary.
4
cC
After changing the engine oil,
5
make sure to check the oil pres-
sure as described below.
6
8 Remove the bleed bolt.
8 Start the engine and keep it
7
idling until oil flows out. If no
oil
comes
out
8
minute, turn the engine off
immediately so it will not
seize. If this occurs, have a
9
Yamaha dealer repair the vehi-
cle.
8 After checking the oil pres-
sure, tighten the bleed bolt to
the specified torque.
Tightening torque:
Bleed bolt:
7 Nm (0.7 m0kg)
ECA00075
after
one
1. Holding clip (×3)
Cleaning the air filter
element
The air filter element should be
cleaned at the intervals specified in
the periodic maintenance and lubrica-
tion chart. Clean the air filter element
more frequently if you are riding in
unusually wet or dusty areas.
6-11
1. Remove panel A. (See page 6-6
for panel removal and installation
procedures.)
2. Remove the air filter case cover
by removing the holding clips.
1
EAU03602