Operation And Important Riding Points; Starting And Warming Up A Cold Engine - Yamaha TT-R TT250RN Owner's Manual

EAU00372
w
8 Become thoroughly familiar
with all operating controls and
their functions before riding.
Consult a Yamaha
regarding any control or func-
tion that you do not thorough-
ly understand.
8 Never start the engine or oper-
ate it in a closed area for any
length of time. Exhaust fumes
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
short time. Always make sure
that there is adequate ventila-
tion.
8 Before starting out, make sure
that the sidestand is up. If the
sidestand is not raised com-
pletely, it could contact the
ground and distract the opera-
tor, resulting in a possible loss
of control.

OPERATION AND IMPORTANT RIDING POINTS

EAU00373
Starting and warming up a
cold engine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
dealer
8 The transmission is in the neutral
position.
8 The transmission is in gear with
the clutch lever pulled and the
sidestand up.
w
8 Before starting the engine,
check the function of the igni-
tion circuit
according to the procedure
described on page 3-14.
8 Never ride with the sidestand
down.
EAU00411
1. Arrow mark positioned over "ON"
1. Turn the fuel cock lever to "ON".
EW000054
2. Turn the key to "ON" and make
3. Shift the transmission into the
cut-off system
NOTE:
When the transmission is in the neu-
tral position, the neutral indicator light
should be on, otherwise have a
Yamaha dealer check the electrical
circuit.
5-1
RES
OFF
FUEL
ON
1
ON
sure that the engine stop switch
is set to "#".
neutral position.
1
2
3
4
5
6
7
8
9