Yamaha TT-R TT250RN Owner's Manual page 50

2
1
1. Oil filter element
2. O-ring (×3)
6. Remove the oil filter element and
O-rings.
7. Check the O-rings for damage
and replace them if necessary.
8. Clean the oil filter element with
solvent, and then install it.
NOTE:
Check the oil filter element for dam-
age and replace it if necessary.
9. Install the oil filter element cover
by installing the oil filter element
cover bolts, then tightening them
to the specified torque.
PERIODIC MAINTENANCE AND MINOR REPAIR
Tightening torque:
Oil filter element cover bolt:
10 Nm
(1.0 m0kg, 7.2 ft0lb)
10. Install the oil filter element drain
bolt, and then tighten it to the
specified torque.
Tightening torque:
Oil filter element drain bolt:
10 Nm
(1.0 m0kg, 7.2 ft0lb)
NOTE:
Make sure that the O-rings are prop-
erly seated.
11. Install the engine oil drain bolt,
and then tighten it to the speci-
fied torque.
Tightening torque:
Engine oil drain bolt:
20 Nm
(2.0 m0kg, 14.5 ft0lb)
6-10
12. Add the specified amount of the
recommended engine oil, and
then install and tighten the oil
filler bolt.
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter element
removal:
1.1 L
With oil filter element removal:
1.2 L
Total amount (dry engine):
1.45 L
cC
8 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives
with the oil.
8 Make sure that no foreign
material enters the crankcase.
1
2
3
4
5
6
EC000066
7
8
9