Table of Contents
Advertisement
Fence Adjustment
1 Make sure that no part of the
tool contacts the upper fence
when bevel or compound mitre
cutting.
Note:
Always make a dry run with
the saw turned off and check
clearance. Tighten securely before
making a cut.
Depth Adjustment (Trenching)
Trenching refers to restricting the depth of cut and permits a "trench" to be
cut in the workpiece.
1 Ensure the cutting head is raised,
and then loosen the depth
locking nut.
2 Using a hex key,
adjust the depth
adjustment screw
so that the cutting
head stops at the
desired height when
lowered.
3 Once the desired setting is
achieved, tighten the depth
locking nut.
4. CONTROLS
Turning On the Worklight or Laser Line
To switch the worklight on, press
the worklight switch up into the on
position.
20
40
50
60
100 120 140 160 180
Laser Line
OFF
WARNING!
BEAM OR WORKLIGHT.
Head Locking Pin
1 To unlock the saw head, press
down slightly on the handle and
then pull and rotate the head
locking pin 90 degrees.
2 To lock the head down, press
the head down and the pull and
rotate the head locking pin 90
degrees.
Starting the Mitre Saw
1 Unlock the trigger by pressing the
lever on the trigger sideways.
Then unlock the handle motion by
pressing the handle lock button
at the front of the handle.
2 Squeeze the on/off
trigger to start the
saw.
Note:
Allow the saw to reach full speed before beginning a cut.
To switch the laser line on, press
the laser line switch up into the on
position.
Worklight
Laser Line
OFF
OFF
DO NOT STARE DIRECTLY AT THE LASER
20
40
20
40
50
60
100 120 140 160 180
Worklight
OFF
90
0
50
60
100 120 140 160 180
Advertisement
Table of Contents
