Table of Contents
Advertisement
2. EXTENSION SUPPORTS
WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
THE BATTERY IS REMOVED BEFORE PERFORMING ANY
OF THE FOLLOWING TASKS.
Adjusting the Extension Supports
The extension supports can be extended outwards allowing additional support
when cutting longer workpieces.
1 Press the support locking lever
underneath the support arm to
allow it to slide.
2 Slide the extension
support to the
desired location
and then release
the locking lever to
secure in position.
Using the Material Stops
The extension supports allow feature a material stop that can be raised in
order to contact the end of the workpiece. This feature is used to quickly
position material enabling you to cut multiple pieces at the same length.
1 Raise the material stop upwards,
then adjust the extension support
to the desired distance away
from the blade.
2 Once the material
stop is set, you can
place the workpiece
onto the table and
slide up to the stop.
Secure the material
and then complete
the cut.
3. ADJUSTMENTS
Bevel Adjustment
1 Loosen bevel locking lever at the
rear of the saw.
20
40
50
60
100 120 140 160 180
2 Tilt the head using
the bevel scale as a
reference.
3 Tighten the bevel locking lever
to secure at the desired bevel
20
40
50
60
100 120 140 160 180
angle.
WARNING!
BEFORE MAKING A CUT. FAILURE TO DO SO MAY
RESULT IN THE CUTTING HEAD MOVING DURING
OPERATION AND CAUSE SERIOUS PERSONAL INJURY.
Mitre Adjustment
1 Loosen the mitre locking knob at
the front of the saw.
20
40
50
60
100 120 140 160 180
2 Rotate the mitre
table to the desired
mitre angle and
then lock in position
using the mitre
locking knob.
20
40
50
60
100 120 140 160 180
Note:
The mitre table features positive click stops at 0°, 5°, 10° 15°, 22.5°,
30°, 35°, 40° and 45° for quick setting of common mitre angles.
20
40
50
60
100 120 140 160 180
ENSURE THE BEVEL LOCK IS TIGHT
20
40
50
20
40
50
60
100 120 140 160 180
60
100 120 140 160 180
Advertisement
Table of Contents
