Setting The Rtc Configuration; System Memory Dram; Atx/At Power Select - IBM NuPRO-630 Manual

2.9 Setting the RTC Configuration

The NuPRO-630 provides a setting for the selection of the RTC Clear Jumper by
JP4 setting as following:
CMOS Setting of JP4:
l
CMOS Clear Jumper
Normal
Clear CMOS

2.10 System Memory DRAM

The NuPRO-630 provides a wide range on-board DRAM memory by three
pieces DIMM sockets (DIMM-1, DIMM-2, DIMM-3) request the access time
should meet PC-100 standard.. The maximum capacity of the on board memory
is 1.5GBytes.
See the figure on section 2.3 for get the identifying the banks.

2.11 ATX/AT Power Select

The NuPRO-630 provides a selection by a three-pin jumper JP8 for setting the
power supply type in using.
ATX/AT Power Select Setting of JP8:
l
Power Supply In Using
AT Power Supply
ATX Power Supply
JP4
* OFF
ON
JP8
* 2-3
1-2
Hardware Installation 2-7