Table of Contents
Advertisement
Chapter-2
Hardware Installation
This ch apter provides the information on how to install the hardware of
NuPRO-630. At first, please follow up sections 1.3, 2.1 and 2.2 in check the
delivery package and carefully unpacking. Following after, the jumpers setting of
switch, watchdog timer and the DiskOnChip™ address selection etc.
2.1 Caution of Static Electricity
The NuPRO-630 has been well package with an anti-static bag in protect its
sensitive computer components and circuitry from the damage of static electric
discharge.
Note:
DO NOT TOUCH THE BOARD OR ANY OTHER SENSITIVE
COMPONENTS WITHOUT ALL NECESSARY ANTI-STATIC
PROTECTION.
You should follow the steps as following to protect the board in against the
static electric discharge whenever you handle the board:
1. Please use a grounding wrist strap o n whoever needs to handle the
NuPRO-630. Well clip the ALLIGATOR clip of the strap to the end of the
shielded wire lead from a grounded object. Please put on and connect the strap
before handle the NuPRO-630 for harmlessly discharge any static electricity
through the strap.
2. Please use anti-static pad for put any components or parts or tools on the pad
whenever you work on them outside the computer. You may also in use the
anti-static bag instead the pad. Please ask from your local supplier in help up
your necessary parts on anti-static requirement.
Hardware Installation 2-1
Advertisement
Table of Contents
