Caution On Unpacking And Before Installation - IBM NuPRO-630 Manual

2.2 Caution on Unpacking and Before Installation

First of all, please follow with all necessary steps of section 2.1 in protection the
NuPRO-630 from electricity discharge. With refer to section 1.3, please check the
delivery package again with following steps:
1. Unpacking the NuPRO-630, keep well storage of all packing material, manual
and diskette etc. if has.
2. Is there any components lose or drop from the board? DO NOT INSTALL
IF HAPPENED.
3. Is there any visual damaged of the board? DO NOT INSTALL IF
HAPPENED.
4. Well check from your optional parts (i.e. CPU, SRAM, DRAM, ROM-Disk
etc.) for completed setting all necessary jumpers setting to jumper pin-set and
CMOS setup correctly. Please also reference to all information of jumpers
setting in this manual.
5. Well check from your external devices (i.e. Add-On-Card, Driver Type etc.) for
completed add-in or connection and CMOS setup correctly. Please also
reference to all information of connector connection in this manual.
6. Please keep all necessary manual and diskette in a good condition for your
necessary re-installation if you change your Operating System or whatever
needs.
2-2 Hardware Installation