Toyota TUNDRA Manual page 498

498
7-3. Do-it-yourself maintenance
◆
Registering ID codes
Every tire pressure warning valve and transmitter has a unique ID
code. When replacing a tire pressure warning valve and transmitter,
it is necessary to register the ID codes.
To register the ID codes, perform the following procedure:
1
Press the tire pressure warn-
ing reset switch 3 times until
the tire pressure warning
light blinks slowly 3 times.
Then a message will be dis-
played
display. When registration is
being performed, the tire pres-
sure warning light will blink for
approximately 1 minute then
illuminate and "--" will be dis-
played for the inflation pres-
sure of each tire on the multi-
information display.
2
Drive straight (with occasional left and right turns) at approxi-
mately 25 mph (40 km/h) or more for approximately 10 to 30 min-
utes.
Registration is complete when the tire pressure warning light
turns off and the inflation pressure of each tire is displayed on the
multi-information display.
Registration may take longer than approximately 30 minutes in
certain situations, such as when the vehicle is stopped for a long
time at traffic lights, etc. (→P. 503)
After registering the ID codes, make sure to initialize the tire
pressure warning system. (→P. 496)
on multi-information