Toyota TUNDRA Manual page 131

Memory recall function
A desired driving position can be recalled linked with the unlocking of
the door.
■
Registering procedure
Record your driving position to button "1" or "2" before performing
the following:
1
Turn the engine switch off and close the driver's door.
2
While pressing the button "1"
or "2", press
less remote control until the
signal beeps.
The driving position is recalled
when the
unlocked using the wireless
remote control and the driver's
door is opened.
To prevent unintended triggering of the alarm, open and close a
door once after a driving position has been recorded. (If a door is
not opened within 60 seconds after
be locked again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm.
(→P. 85)
■
Cancelation procedure
1
Turn the engine switch off and close the driver's door.
2
While pressing the "SET" button, press
remote control until you hear 2 beeps.
■
If the battery is disconnected
The recorded seat positions are erased when the battery is disconnected.
WARNING
■
Seat adjustment caution
Take care during seat adjustment so that the seat does not strike the rear
passenger or squeeze your body against the steering wheel.
on the wire-
driver's door is
3-3. Adjusting the seats
is pressed, the doors will
on the wireless
131
3