Warranty Conditions - Salicru SPS 750 ADV R User Manual

Symptom
A66
A68
A86
Error Codes
e6
e7
e8
e9
e11
e12
e14
e15
e18
e19
Tab. 13. Troubleshooting guide.

8.3. warranTy CondiTions.

8.3.1. Terms of the warranty.
on our website you will find the warranty conditions for the
product you have purchased where you can also register it. It is
recommended to do so as soon as possible to include it in the
database of our Technical Service and Support (T.S.S.). Among
other advantages, it will streamline any regulatory procedures
for the intervention of
8.3.2. exclusions.
Our company will not be bound by the warranty if it notices
that the defect in the product does not exist or was caused by
improper use, negligence, improper installation and/or verifi-
cation, attempts at unauthorized repair or modification, or any
other cause beyond the intended use, or by accident, fire, light-
ning or other hazards. nor shall it cover any compensation for
damages.
8.4. TeChniCal serviCes neTwork.
Information about our national and international Technical Ser-
(T.S.S.)
vice and Support
USER MANUAL
Possible cause
ePo activated:
open ePo terminals
overtemperature:
Ambient temperature too high.
Low inverter output voltage:
Low inverter output voltage protection will be
activated.
Inverter soft-start fault:
device starting fault.
high inverter output voltage: Inverter output voltage
too high.
Low inverter output voltage: Inverter output voltage
too low
output short circuit
high battery voltage.
Low battery voltage.
overload at the output.
Unbalanced loads.
fan fault.
overtemperature.
T.S.S.
in the event of a fault.
centres can be found on our website.
Solution
Connect ePo terminals
disconnect non-essential loads from device.
Check that fan is working correctly and that UPS's air inlets and outlets have not been
blocked.
Check AC input connection.
disconnect loads.
Contact distributor, seller or, failing that, our T.S.S.
Turn off UPS.
disconnect non-essential loads from device.
Turn off UPS.
disconnect non-essential loads from device.
Turn off UPS.
Loads may have a problem, disconnect and check them.
Turn off UPS.
Check battery voltage.
Turn off UPS.
Check battery voltage.
Check battery cable terminals on b1 devices.
disconnect non-essential loads. If overload problem solved, devices will go into
normal mode.
Turn off UPS.
Check device's loads.
Contact distributor, seller or, failing that, our T.S.S.
Turn off UPS.
Turn on again and check that fan is working correctly and that UPS's air inlets and
outlets have not been blocked.
SPS ADVANCE R & T UnInTeRRUPTIbLe PoweR SUPPLy (UPS)
23