Table of Contents
Advertisement
Step 7
BP20
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the back right corner
of the building. Each screw and bolt
in the roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels t better, and holes will
align. Don't anchor the oor frame.
1
Locate all the roof panels by their
numbers and place them on the
gound alongside the building in their
proper positions.
2
Position a right roof panel at the
back right corner and fasten to the
gable and roof beam using screws as
shown. Do not fasten the lower end
of the panels to the side wall angles
at this time.
3
Install a left roof panel at the left
rear corner of the roof.
4
Cover the joint at the peak with
weather stripping tape. Unroll the
tape and press it down over the
opening at the ridge as you install
each roof panel. Do not cut the tape
at this time.
5
Install a left and right roof panel
in the sequence and positions shown.
Follow fastener sequence.
6
Unroll the weather stripping tape,
press it down rmly, and cut it.
7
Fasten the lower end of the panels
to the side wall angle using screws
and washers.
Parts Needed For
Roof Assembly
If roof beam holes do not line up with
the roof panel holes, shift the building
from left to right. If this does not help,
your building may not be level. Shim
the corners until holes line up.
2
9727
3
9726
STEP
5
9726
Cut
Weather Stripping
and Fold Under
STEP
6
20
NOTE
1
4
Front
STEP
1
6
Washer
STEP
4
STEP
3
Weather Stripping
Tape
9727
9727 Left Roof Panel
STEP
5
9726 Right Roof Panel (2)
9727 Left Roof Panel (2)
9726
9727
STEP
2
9726 Right Roof Panel
4
5
1
2
STEP
7
3
Advertisement
Table of Contents
