Arrow EH54-A Owner's Manual & Assembly Instructions page 18

Step 5
BP18
Each wall panel has a crimped rib on
one side. The crimped rib should go
under the rib of the adjacent panel.
The door jambs reinforce the door
opening and provide an attractive
trim.
1
Fasten the front wall panel to the
left front corner, as shown. Fasten
overlapping rib as before.
2
Fasten the door track assembly
across the top of the front wall panel
using screws. See the gure.
3
Fasten the center of the right door
jamb to the right corner panel with a
bolt and nut. Fasten the top of the
jamb to the door track with a 7/8" (22
mm) screw and a plastic spacer, as
shown. Do the same for the bottom.
4
Fasten a left door jamb to the
front panel with three bolts, nuts and
acorn nuts, as shown. Push a plug
into hole at center of jamb, closest
to door opening. Fasten the top of
the jamb to the door track with two
screws. Do the same for the bottom
into frame.
5
Fasten wall panel to the rear of
building, as before.
Parts Needed For
Panels/Track/Jambs
STEP
1
9456
Top View
Door Track
TOP VIEW
Bolt
Door Track
STEP
7/8" (22 mm)
3
Hex Nut
STEP
4
Plug
Bolt
Acorn Nut
Screw
18
Plastic Spacer
9698
7/8" (22 mm)
Screw
Spacer
Screw
6627
9456 Front Wall Panel (1)
Door Track Assembly (1)
9698 Door Jamb (1)
9370 Door Jamb (1)
6627 Wall Panel (1)
STEP
2
Long Leg
on Top
Opening
Facing in
Short Leg
on Bottom
STEP
5
TOP VIEW
3 Bolts
Door Track
9370
TOP VIEW
Door Track
Screw
Screw