Configuration Of The I/O Devices; Et 200M As Dp Slave (H System And Standard As) - Siemens SIMATIC PCS 7 Configuration Manual

6.5

Configuration of the I/O devices

Information on configuring peripheral devices can be found in the "Released PCS 7 Modules"
manual. The components and modules listed in the manual have been tested with PCS 7 and
are supported from the PCS 7 "Generate module drivers" function. These released PCS 7
modules can be selected within the hardware configuration catalog from the "PCS 7 V8.1"
profile.
6.5.1

ET 200M as DP slave (H system and standard AS)

Introduction
The following describes the configuration of an ET 200M station as a typical DP slave. The
name of the DP slave should be based on the naming conventions for a plant or plant network
to allow you to quickly locate faults in case of servicing.
Note
The exact step-by-step description for configuring an ET 200M station can be found in the
"SIMATIC Process Control System PCS 7 Engineering System"
support.industry.siemens.com/cs/ww/en/view/109485969) manual.
Example: 2550C01CA04
25:
50:
C01C: Name and position of the rack
A04:
If an error occurs in the DP subnet, a message containing information about the position of
the faulty slave is generated on the OS.
Compendium Part A - Configuration Guidelines (V8.2)
Configuration Manual, 08/2016, A5E38166869-AA
Short designation of the production facility
Name of the control room
Module slot
Configuration of the hardware (AS and I/O)
6.5 Configuration of the I/O devices
(https://
113