Configuration Management; Keypad/Display Interface; Web Interface - Microsemi SyncServer S600 User Manual

Chapter 1 Overview

Configuration Management

Note: The SyncServer S6x0 uses IRIG 1344 version
C37.118.1a-2014.


Configuration Management
The SyncServer S6x0 can be configured using the keypad interface, web interface
or Command Line Interface.

Keypad/Display Interface

The keypad/display interface displays the time, system status, and provides the
following functions:
Configuring and enabling/disabling the LAN1 network port

Setting the time and entering freerun mode

Adjusting the brightness

Locking the keypad

Shutting down the SyncServer


Web Interface

The SyncServer S6x0 also allows the user to access information via the LAN1
Ethernet port using HTTPS protocol. To use the SyncServer S6x0 web interface,
enter the IP address for Ethernet port 1 into a web browser. Enter your user name
and password for the SyncServer S6x0 when prompted.
Dashboard View
See Figure 1-34
44 SyncServer 600 Series User's Guide
On the input side, the code performs a subtraction using control
bits 14 - 19 from the supplied IRIG time with the expectation that
this will produce UTC time. This aligns with the C37.118.1a-2014
definition.
On the output side, control bits 14 - 19 will always be zero, and
the encoded IRIG time will be UTC (if using an input 1344 IRIG
as the reference the 2014 rules are applied to get that value).
Hence, any code receiving S6x0 IRIG 1344 output should work
regardless of which version they are decoding (since there is
nothing to add or subtract).
for an example of the dashboard status screen that will appear.
098-00720-000 Revision D1 – February, 2018