It is important to note that every standard I/O on the block is setup as a freely configurable port. If the controller is programmed to look for an input
and there is an input wired there, it will be an input. If the controller is programmed to fire an output, it will be an output there. There are diagnostic
inputs available that will indicate an overload on an output from the master block.
Standard Output Data
Description
Output Data
(Pin Number of Output)
Restart Output (after overload)
(Pin Number of Output)
Reserved Data
DL: Display Lock / PLC Lock
GN: Display Green LEDs ON
RD: Display Red LEDs ON
IO-Link Ports – Output Data
Description
IO-Link Slave Device Specific Data
(organized by bytes of data in the input buffer of the master block)
Byte
Bit (block pin #)
7
6
5
4
0
07
06
05
04
1
15
14
13
12
2
07
06
05
04
3
15
14
13
12
4
0
0
0
0
5
0
0
0
0
(organized by bytes of data in the input buffer of the master block)