Connect The Distributed Modular I/O Master Block; M12 Network Port; 7/8" Auxiliary Power Port; M12 I/O Port - Balluff BNI004A Quick Start Manual

Connect the Distributed Modular I/O Master Block

1. Using an M12 D-coded EtherNet/IP cable, connect the block to the Ethernet network.
1
2. Power up the block using 24VDC and a 7/8" 4pole connector wired according to the below diagram.
3. Set the IP address of the block using the pushbutton display. For instructions on operating the display, see the manual.
Port 0
00
Port 1
02
Port 2
IO-Link 1
04
Port 3
IO-Link 2
06
Network
Pushbutton Display
IP address subnet mask
gateway
Aux Power
Port 4
01 08 09
Port 5
03 10 11
Port 6
IO-Link 3
13
05 12
Port 7
IO-Link 4
07 14 15

M12 Network Port

Pin Function Description
1 TX + Transmit Data +
2 RX + Receive Data +
3 TX - Transmit Data -
4 RX - Receive Data -

7/8" Auxiliary Power Port

Pin Function Description
1 + 24 V Actuator Supply
2 + 24 V Sensor/Bus Communication Supply
3 0 V Sensor/Bus Communication Supply
4 0 V Actuator Supply

M12 I/O Port

Pin Configurable Port IO-Link Port
1 + 24 V + 24 V
2 Input 2 or Output 2 Input/Output 2
3 0 V 0 V
4 Input 1 or Output 1 IO-Link or Input/Output 1
5 FE FE
2