Secure The Generator - Baldor TS25 Installation & Operating Manual

Several other factors should be carefully evaluated when selecting a location for installation:
TS130/175 only
A1
(4 Holes)
TS25/45/80 only
(3 Holes)
Generator A
TS25 74.0
TS45 84.0
TS80 84.0
TS130 118.0
TS175 118.0
Secure the Generator (Skid Mount only)
Six mounting bolts (eight for TS130/175) in the base frame secure the generator to the shipping
pallet. Remove these bolts, lift the generator and remove the shipping pallet. Secure the
generator to the concrete pad using anchor hardware (not provided) in the base frame mounting
holes (holes are 0.66" diameter). See Figure 3-2 and Table 3-1. Anchor bolts must be long
enough to extend through the generator mounting frame.
3-2 Receiving & Installation
1. For effective cooling and maintenance, the system should be mounted on a flat,
smooth, noncombustible level surface. A concrete pad is ideal and provides a secure
installation.
2. Installation should prevent water levels from reaching the generator. Drainage must be
adequate to keep concrete pad free from standing water.
3. Installation should prevent obstructions by buildup of leaves, grass, sand, snow, etc. If
these items pose a problem, consider building a small fence or other break to protect
the unit from accumulation of debris.
4. Installation should place the generator as close as possible to the transfer switch.
5. At least forty−eight (48) inches clearance must be provided on all sides for air flow.
6. Access must be provided to allow the enclosure covers to be opened or removed for
service and maintenance.
7. Maximum Ambient temperature is 122°F (50°C).
Figure 3-2 Generator Mounting (Skid)
A
A2
A2
Table 3-1 Mounting Dimensions
A1
8.12
8.38
8.38
16.57
16.57
A2
A2
A2 B
23.81 38.0
28.56 38.0
28.56 38.0
26.57 42.0
26.57 42.0
B1
B
A1
A1
B1 B2
36 6.25
36 6.25
36 6.25
40 6.25
40 6.25
MN2416