Safety Checks - Baldor TS25 Installation & Operating Manual

Jack
Coupler Handle
Coupler
Safety
Chains
Ball Coupler
Caution: Large "Engine Compartment Doors" on each side of enclosure must remain closed during
operation. If doors remain open, engine will overhead due to restricted air flow.
Safety Checks The following items should be checked before each use and once every 100 miles of towing:
MN2416
Figure 4-1 Trailer Component Identification
Tow Vehicle Mounted
Pintle Hook
Pintle
Safety
Chains
1. Verify the tow vehicle is designed to tow the trailer before trailer is connected to the
vehicles hitch. Using a tow vehicle that is too small is very dangerous.
2. Verify the stop, tail and turn signals are working properly.
Replace damaged lenses, reflectors or bulbs.
3. Check wires for good connections and possible fraying or wearing of insulation.
4. Check and properly maintain the trailer, hitch, jack, ball and coupler.
5. Inspect hitch and ball for damage. Ball or hitch can be damaged in parking, hitting
curbs, dragging when crossing ditches or railroad tracks.
6. Check and properly tighten all bolts on trailer, hitch, ball and coupler (including wheels).
7. Check safety chains for wear and do not allow them to drag on ground or roadway.
8. Test breakaway system.
Hydraulic surge brake system, normally has a cable or chain connected to the tow
vehicle. In a break away condition, this cable or chain activates the master cylinder and
operates the brakes as the trailer stops.
An electric brake system, the emergency breakaway system has a battery, charger,
breakaway switch with a pull pin and cable connected to the tow vehicle. In a break
away condition, this cable operates the electric brakes (power provided by the brake
battery) as the trailer stops.
9. Check all generator mounting hardware for tightness. (Loosens with vibration).
10. Check tow vehicle tires for wear and proper inflation (check vehicle's owner manual for
proper level of inflation of tires for towing a trailer).
11. Check trailer tires for wear and proper inflation. Replace only with a tire of the same
size and capacity ratings.
12. Carry emergency flares, reflectors and fire extinguisher (required in some states).
13. Carry spare light bulbs and fuses.
14. Wheel bearings should be checked and replaced after the first 100 miles, and every
4000 miles thereafter or at least once a year. Wheel bearing grease or a good grade of
multi−purpose grease should be used for packing wheel bearings. If you don't know
how to repack your wheel bearing, take your trailer to a service shop. Be sure to
properly tighten the axle nut and wheel nuts during assembly.
15. For proper tow vehicle maintenance while towing a trailer, check vehicle's owner
manual and manufacturer's specifications.
Battery
Compartment
Trailer Brake
Trailer
Jack
Lift Hook
Single or
Double Axle
Engine
Compartment
Operation 4-3