Baldor TS25 Installation & Operating Manual page 27

Note: The exhaust also exits radiator end. When positioning a generator system ensure position
Caution: Large "Engine Compartment Doors" on each side of enclosure must remain closed during
operation. If doors remain open, engine will overhead due to restricted air flow.
VOLTAGE
Battery Engine
Volts Temp
Panel Lights switch (On−Off )
Turns on two lamps to illuminate the operator panel.
Panel Light Fuse Fuse for panel lights.
Filed Fuse Fuse for generator field.
Controller Fuse Fuse for engine controller.
Master Control switch (Manual Run−Stop − Auto Start)
Manual Run − Starts the engine manually.
Stop − Stops the engine and generator.
Auto Start − Starts the engine from a remote source whenever the
utility AC power is lost.
Fault Display Lamps
High Temperature − Indicates excessive engine coolant temperature.
Low Oil Pressure − Indicates low engine oil pressure (<15PSI).
Overspeed − Indicates engine speed is greater than preset limit.
Overcrank − Failure of the engine to start by the end of the crank period
results in an overcrank" shutdown and alarm indication.
Voltage Adjust
Increase or Decrease the Generator output voltage (displayed on
VOLTAGE meter)
MN2416
c. Adequate clearance must be provided for access doors to fully open.
does not cause a concentration of toxic emissions.
5. Switch the generator set to the applicable voltage setting.
6. Connect the load(s) at the Receptacle panel connections (Figure 4-3).
7. Verify that all electrical cables and wiring are in good condition, no cracked or frayed
wires or cable insulation.
8. Ensure that an external ground connection is made when required for safety.
9. Ensure that Engine Compartment doors are closed for proper ventilation.
Figure 4-2 Operator Control Panel
Panel Light
HERTZ
AMPERAGE
Oil Pressure
AMMETER
3
RUN TIME (HOURS)
CONTROLLER FUSE
FIELD FUSE
PANEL LIGHT FUSE
PANEL LIGHTS
OFF
1 ON OFF
2
Voltage meter
Analog display of generator output voltage in RMS volts.
AMMETER switch (3 position)
Off − No current is measured by the Amperage meter.
1 − Phase 1 current is measured by the Amperage meter.
2 − Phase 2 current is measured by the Amperage meter.
3 − Phase 3 current is measured by the Amperage meter.
Amperage meter
Analog display of generator output current in RMS amps.
Hertz meter
Analog display of generator output frequency in Hertz.
Battery Volts meter
Displays the voltage of the engine starting battery.
Engine Temperature meter
Displays the temperature of the engine coolant.
Oil Pressure meter
Displays engine oil pressure.
Run Time (Hours) meter
Total elapsed time indicator of generator set operation.
Panel Light
HIGH TEMPERATURE
LOW OIL PRESSURE
OVERSPEED
OVERCRANK
STOP
MANUAL
− +
RUN
MASTER
VOLTAGE
CONTROL
ADJUST
Operation 4-5
AUTO
START