Table of Contents
Advertisement
of electrical cords and, more specifically, power strips, as this type
of overload can result in a risk of fire or electrical shock.
When using the encoder, employ an outlet that contains surge
suppression and ground fault protection. For added protection
during a lightning storm or other dangerous weather, or when the
encoder is left unattended and/or unused for long periods of time,
unplug the power cord from the wall outlet and disconnect the lines
between the encoder and the video source.
Always carefully handle the encoder. Avoid excessive shock and
vibration to the encoder at all times, as these conditions can damage
the encoder and/or cause personal physical injury or death to you
and/or others.
Warranty
The following information is a general warranty overview.
For complete warranty details, please refer to the specific warranty
included with each product.
Cisco Systems warranties are pass through warranties to the end
user.
Cisco Systems warrants all Cisco Systems software Products to
meet their current published specifications as stated in the
applicable Software License Agreement or other license document
supplied with the Software Product. Cisco Systems assigns any
warranties it may have from any third party suppliers of Products to
the Reseller or end user. Any modification voids this warranty or
any other existing or available warranties. Cisco Systems hardware
Products are warranted against defects in material and workmanship
under normal use for the period of 24 months from date of sale (12
months for GoStream). Where specific warranties exist that provide
more substantial coverage, then notwithstanding the warranty
provisions herein, such Product warranties shall be controlling and
shall preempt or supersede the warranty provisions herein.
Before installing the Cisco Digital Media Encoder 2000, read and
comply with the following safety warnings to ensure that you do not
Safety
damage the equipment or cause personal injury.
Warnings
• WARNING: Installation of the equipment must comply
• WARNING: Read the installation instructions before
• WARNING: Only trained and qualified personnel should
• WARNING: This product requires short-circuit
with local and national electrical codes.
connecting the system to the power source.
be allowed to install, replace, or service this equipment.
-9-
I
G
NSTALLATION
UIDE
Advertisement
Table of Contents
