Table of Contents
Advertisement
I
G
NSTALLATION
UIDE
encoder is unused for long periods of time.
To reduce the risk of fire or electric shock, do not expose the
encoder to rain or moisture of any kind. Exposing the encoder to
rain or other types of moisture could result in impairment to the
encoder and physical injury or death to you and/or others.
Encoder shall not be exposed to water or moisture in any way.
Liquids in any form should not be placed on or near the encoder. If
you place liquids in any form on or near the encoder, do so at your
own risk, for there is a high risk of electrical shock that could occur,
which may cause damage to the encoder and/or personal physical
injury or death to you and/or others.
Refer all servicing to authorized service personnel. Servicing is
required when the encoder has been damaged in any way, such as
the power supply cord or plug is damaged, liquid has been spilled
on the encoder, or objects have fallen into or onto the encoder, the
encoder has been exposed to rain and/or other types of moisture,
does not operate as described in the user guide, or has been dropped.
This list is nonexclusive. Cisco Systems assumes no liability or
responsibility for any encoder still in use that has been damaged in
any way, manner or form.
With the encoder, employ only attachments, accessories and/or any
and all other equipment specified by the manufacturer.
Do not use accessories or attachments not recommended by the
encoder manufacturer. This will void the Limited Warranty.
Do not in any manner attempt to service the encoder yourself, as
opening or removing covers may expose you to dangerous voltage,
and will void the Limited Warranty. Refer all servicing to
authorized service personnel.
Protect the power cord from being walked on, strained or pinched in
any way, particularly at plugs, electrical receptacle, and the point
where the power cord exits from the encoder.
Do not use adapter plugs or remove the grounding prong from the
power cable.
Operate the encoder using only the type of power source indicated
on the marking label on the back panel of the unit. Unplug the
encoder power cord by gripping the power plug and removing the
plug from the power source. Do not pull the cord to remove the
power source from the encoder.
Do not plug the encoder into a wall outlet that contains an overload
-8-
Advertisement
Table of Contents
