Advertisement
Package Contents
• 8MP Network Bullet Camera
• 4× Mounting Screws & Drywall Anchors
• Security Screwdriver
• Mounting Template
• RJ45 Cap
• Video Test Cable
Camera Overview
B
E
A
A. Light Sensor and IR LEDs
D. Camera Base
B. Sun Shield Screw
E. Service Compartment
C. Adjustment Screw
Service Compartment Overview
A
Use the included security screwdriver to open the
compartment cover.
A. microSD Slot: Insert a microSD
card (not included) into the slot.
E
microSD card Class 10
supported.
B. For service purposes only.
C. Reset Button: Press and
D. Manual Zoom In/Out: See
hold the button for
"Adjusting Zoom and Focus"
5 seconds using a
section for details.
thin object to reset the
E. For service purposes only.
camera to default settings.
Close the compartment cover and secure the screws
B
when finished.
Installing the Camera
Test the camera prior to selecting a permanent mounting location by
temporarily connecting the camera(s) and cables to the NVR.
Use the included mounting template to mark holes for
1
the mounting screws and camera cable.
Drill holes for the mounting screws and camera cable.
2
NOTE:
Use the included drywall anchors if needed.
Connect cables as shown in the section "Connecting the
3
Camera".
Attach the camera base to the mounting surface using
4
the included mounting screws (4×).
D
C
5
Use the included security screwdriver to loosen the
adjustment screw on the camera base. Make the
necessary camera angle adjustment.
A
B
C
D
6
Tighten the adjustment screw when finished.
7
Remove the vinyl film from the camera lens when your
installation is complete.
ATTENTION:
Drywall
Mounting
anchors (4×)
screws (4×)
Camera
Mounting
base
surface
Adjustment
screw
N357B8_QSG_EN_R2
Connecting the Camera
A
B
C
A
Power Input: If not using PoE, connect the camera to a
24VAC power source. See the rating label on the camera
for minimum power requirements.
B
Alarm I/O (optional): Connect alarm/sensor devices (not
included).
C
Ethernet Connector: Connect the camera to an NVR
or a router or switch on your network using CAT5e or
better Ethernet cable (not included). PoE+ supported
(802.3at).
NOTE:
For instructions on weatherproofing the Ethernet
connection, see "Using the RJ45 Cap (Optional)" on the
back of this guide.
Audio I/O (optional): Connect a self-powered microphone
D
(audio in) or speaker (audio out).
ATTENTION:
You must connect the camera to a supporting H.265 NVR to take
advantage of H.265 compression. For more information, see your IP
camera's instruction manual on flir.com/security/pro.
Adjusting Zoom and Focus
Adjust the camera's zoom and focus using an NVR, the web interface,
or on the camera. For more information, see your NVR's instruction
manual on flir.com/security/pro.
NVR: Right-click on the camera's live view and then click
A
AutoFocus. Use the sliders to adjust the zoom and focus.
Web Interface: Use the controls in the right-hand panel to adjust
B
the zoom and focus.
C
Manual Zoom In/Out: Located in the camera's service
compartment, press T to zoom in and W to zoom out.
D
Advertisement
