Table of Contents
Advertisement
9
134
Remove bulb 2 from
light housing by turning it
counterclockwise.
z
Replace defective bulb.
Do not touch the glass of
new bulbs with your fin-
gers. For installation, use a clean,
dry cloth. Dirt deposits, in par-
ticular oil and grease, interfere
with heat radiation from the bulb.
Overheating and therefore short
service life of the bulbs are the
consequence.
Bulbs for flashing turn
indicators, front
RY10W / 12 V / 10 W
Bulbs for flashing turn
indicators, rear
RY10W / 12 V / 10 W
Install bulb 2 by screwing
clockwise into light housing.
Insert inside end of lens into
light housing and close.
Install screw 1.
Advertisement
Table of Contents
