Daily Operation; Starting; Using The Start Button - ResMed Sullivan Comfort Operating Manual

1 Connect the air tubing to the mask and flow generator. Switch the main power
switch at the rear of the unit to on (I). (See section 3, Preparing for use.)
The unit will either be in standby mode (as indicated by the light above the
STOP button) or it will start operating – depending on whether the unit was
in standby or operating when it was last switched off at the rear.
If the unit starts operating, •press the STOP button to put the unit in standby.
2 Fit the mask to your face (see section 4, Fitting the mask).
3 Settle down in bed and adjust the air tubing so it is free to move with you if
you turn in your sleep. Do not leave long lengths of tubing around the top of
your bed which could twist around your head or neck while sleeping. You
may bring the tubing over the top of your headboard to reduce drag on the
mask. Or you may prefer to run it across your shoulder.
You are now ready to start the flow generator.
Adjust the air tubing – try both ways and
select whichever is more comfortable
Start the flow generator by pressing the START button. The pressure will rise
quickly to your set pressures – the IPAP and EPAP pressures prescribed by your
physician and set by the sleep clinic staff or your equipment supplier.