(Connection With Commercially Available Controller); (Optical Fiber System/Audio Connection Using Poe++); System Example - Panasonic AW-HR140PJ Operating Instructions Manual

Installation Instructions
Connections (continued)
System example 4 (connection with commercially available controller)
• Configure the MODE switches at the connector panel of the unit.
For details on the MODE switches, see "MODE switch settings" (→ page 8).
• Configure the following items in the camera menu.
1. Display [System] menu - [Protocol] - [Model Select].
2. Select [SEVIHD1], [SBRC300], or [SBRCZ330] for the protocol type.
<NOTE>
• The unit is not equipped with a daisy-chain connection function for connecting multiple units.
System example 5 (optical fiber system/audio connection using PoE++)
HD Integrated Camera AW-HR140
POWER/
10BASE-T/ STANDBY SDI OUT
RS-422 100BASE-TX G/L IN 1/PM
12V IN
ACT LINK
SIGNAL GND
AUDIO IN(1/2)
DC power supply
PoE++ compatible switching hub or
injector
16
Serial connector
Communication
connector
Commercially
available controller
2
MODE
EXT
DC power supply
SDI signal
Transmitter
(transmitting side)
Audio signal (CH1/CH2)
Line input is used for the unit's external audio input.
When connecting a microphone or other devices with different levels, match the level
using an amp, for example.
HD Integrated Camera AW-HR140
POWER/
10BASE-T/ SDI OUT
STANDBY
RS-422 100BASE-TX G/L IN 1/PM 2
MODE
12V IN
EXT
ACT LINK
SIGNAL GND
AUDIO IN(1/2)
External DC
power supply
SDI/optical signal conversion module
Receiver
(receiving side)
Optical fiber cable
SDI signal
SDI monitor