Cooktop Surface; Stainless Steel Surfaces; Oven Air Vents; Control Panel - Kenmore 721.7603 series Use & Care Manual

36
CARE AND CLEANING

Cooktop Surface

To avoid burns, do not clean the cooktop surface until it has cooled.
Foods with high acid or sugar content could cause a dull spot if
allowed to set. Wash and rinse as soon as the surface has cooled,
before using the range again. For other spills such as oil/grease
spattering, etc., wash with soap and water when the surface has
cooled. Then rinse and polish with a dry cloth.
NOTE
Do not lift the cooktop surface. Lifting the cooktop surface can
lead to damage and improper operation of the range.

Stainless Steel Surfaces

To inquire about purchasing stainless steel appliance cleaner or
polish, or to find the location of a dealer nearest you, call
1-844-553-6667 (U.S.A.) or 1-800-469-4663 (Canada). or visit our
website at: www.kenmore.com
NOTE
y Do not use a steel wool pad; it will scratch the surface.
y To clean the stainless steel surface, use warm sudsy water or
a stainless steel cleaner or polish.
y Always wipe in the direction of the metal surface finish.

Oven Air Vents

Air openings are located at the rear of the cooktop, at the top and
bottom of the oven door, and at the bottom of the range.
NOTE
Do not block the vents and air openings of the range.
They provide the air inlet and outlet that are necessary for the
range to operate properly with correct combustion.

Control Panel

To prevent activating the control panel during cleaning, unplug the
range. Clean up splatters with a damp cloth using a glass cleaner.
Remove heavier soil with warm, soapy water. Do not use abrasives of
any kind.

Front Manifold Panel and Knobs

It is best to clean the manifold panel after each use of the range.
For cleaning, use a damp cloth and mild soapy water or a 50/50
solution of vinegar and water. For rinsing, use clean water and polish
dry with a soft cloth.
NOTE
y Do not use abrasive cleansers, strong liquid cleaners, plastic
scouring pads or oven cleaners on the manifold panel. Doing
so will damage the finish.
y Do not try to bend the knobs by pulling them up or down
or by hanging a towel or other objects on them. This can
damage the gas valve shaft.
y The control knobs may be removed for easy cleaning.
y To clean the knobs, make sure that they are in the OFF
position and pull them straight off the stems.
y To replace the knobs, make sure the knob has the OFF
position centered at the top, and slide the knob directly onto
the stem.
NOTE
To prevent scratching, do not use abrasive cleaners on any of
these materials.