Hansaton soundHD 13 Instructions For Use

Your Hearing System.
sound/soundHD 1
Wire – connects the speaker unit to your hearing systems
1a
Earhook
2 2
Microphone / Microphone shield
1
3 3
Push button – switches between listening programs and/or
changes the volume level (depending on individual fitting)
1
4 Battery door
2
5 Dome (Olive)
6 Retention piece – helps prevent the dome and wire from moving
4
out of the ear canal
7 External receiver
5
7a Slim tube (mini tube)
7
8 Earmold
6
8
7
Which System Goes in Which Ear:
Red = right ear Blue = left ear
soundHD S312
sound 13 sound 312
Option: Slim tube (with mini tube)
soundHD 13 soundHD 312 soundHD S312e
Option: Remote control
7a
jam/jamHD
• Refer to the remote control user guide.
1a
2 2
Hörsystem: FCC ID:
sound 13 VMY-UWBTE1
3 3
soundHD 13 VMY-UWNB1
2
sound 312 VMY-UWCRT2
2
soundHD 312 VMY-UWNB0
8
5
soundHD S312 VMY-UWNB2
4
soundHD S312e VMY-UWNB2
4
jam 13 P VMY-UWBTE1
jamHD S13 P VMY-UWNB1
jamHD RS13 P VMY-UWNB3
jamHD S312 M VMY-UWNB4
jamHD S312 M
jam 13 P jamHD S13 P
Conformity to directive
93/42/EEC concerning
jamHD RS13 P
0124
medical devices
Replacing the Battery. Turning Your Hearing Systems on and off.
Battery type: Low Battery Warning With Battery Door
Two long beeps indicate the hearing system battery is
13
low. After the low battery warning, sounds may not be 1. On:
as clear. This is normal and can be fixed by changing
• Close the battery door fully.
312
the batteries in the hearing systems.
If you are not able to hear the low battery warning,
Note: It may take 5 seconds before the
your hearing system professional can change its pitch
hearing system turns on. Your hearing healthcare
or loudness. If you prefer, it can be turned off entirely.
provider can increase the start up delay if
required.
2. Off:
• Open the battery door. • Partially open the battery door.
•
Insert the battery into the battery
compartment, so that the negative pole
faces into the door.
+ –
3. Open:
• Fully open the battery door to access and
change the battery.
• Close the battery door.
Note: To switch the hearing system on
your ear on or off, hold the device between your
thumb and forefinger.
Open and close the battery compartment with
the forefinger of your other hand. Use the index
finger of your opposite hand to open and close
!
the battery door.
With a new battery, it may take a few
minutes for the battery to develop its full
output. Only then should you close the
battery door.
Operating Element. Adjusting Volume.
Without Operating Element With Pushbutton
If the pushbutton has been configured as a volume control, you can
adjust the volume level by pushing the + or – button.
With Push-
Program change
Push the button on your right hearing system to increase the volume
button
in both hearing systems.
Volume control:
Push the button on your left hearing system to decrease the volume
right/left device – louder
in both hearing systems.
As you change the volume, your hearing systems will beep.
Volume control:
right/left device – quieter
With Lever
Volume control:
right device – louder, left device – quieter
• If the lever has been configured as a volume control, you can adjust
the volume of your hearing systems.
Combination:
Press up to increase; press down to decrease. As you change the
Program change – right device and
volume level, your hearing systems will beep.
volume control – left device
Combination:
Volume control – right device and
With Remote Control
program change – left device
• Refer to the remote control user guide.
With Lever
The lever on your hearing systems can be
set up as a volume control.
Volume setting Beeps
louder
Suggested volume level
quieter Turning volume up
Turning volume down
Maximum volume level
Minimum volume level
With Remote Control
• Refer to the remote control user guide.
Switching Hearing Programs. Optional Functionalities.
With Pushbutton
• Use the program pushbutton to select one of the hearing programs • If wireless synchronization is enabled, then changing the volume or
individually programmed for you. program setting on one hearing system, will automatically make the
change to both hearing systems at the same time. Wireless synchroni-
• When changing, your hearing system uses signal sounds to indicate
zation works for both the push button and the lever.
which program you have selected.
•
Please refer all questions concerning your hearing system to your
• You can thus adjust your system to the relevant hearing situation.
hearing system professional.
Program 1 (e.g. AutoSurround) 1 beep
Program 2 (e.g. speech in noise) 2 beeps
Program 3 (e.g. PhoneConnect) 3 beeps The Bi feature enables you to hold a phone to one ear and hear the
sound clearly in both ears. No accessories are required.
Program 4 (e.g. music) 4 beeps
PhoneConnect short melody
Wireless synchronization Opposite ear beeps the same
• allows you to turn the hearing systems on with an automatic delay of
(if enabled) as side being adjusted
5, 10, or 15 seconds to avoid feedback (whistling).
With Remote Control
• Refer to the remote control user guide. The telephone coil allows inductive signal reception (e.g.,
when telephoning). The reception of noise through the micro-
phone is reduced or suppressed.
1 beep
Hearing Program/Description
short beep
short beep 1
If your hearing system professional has configured both a Tinnitus
Manager program and a volume control, you can adjust the Tinnitus
2 beeps
Manager level while you are in the Tinnitus Manager program.
2
2 beeps
3
4
Wireless Synchronisation (BiLink)
Binaural Phone (BiPhone)
Power-on-Delay
Telephone Coil
Tinnitus Manager