Service And Adjustments - Bushranger 53AH6IMSP Operator's Manual

Table of Contents

Advertisement

SERVICE AND ADJUSTMENTS

CAUTION: BEFORE YOU CHANGE SETTINGS OR
MAINTENANCE TASKS:
1. Release drive control bar to stop the lawn mower.
2. Make sure the blade and all moving parts have
stopped completely.
3. Disconnect cable from the spark-plug and place
where it cannot come in contact with plug.
4. Make sure that all the nuts, bolts and screws
are tightened and the device in a safe condition.
5. Let the mower to cool before using it in a
closed area off.
6. In order to avoid the risk of fire, keep motor
housing and ventilation openings free of grass,
leaves and oil or fat.
7. Replace worn out or damaged parts for
security reasons.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation
section of this manual.
TO ADJUST HANDLE
The handle on your lawn mower has different
height positions-adjust to height that suits you.
1. Loosen the 2 lever A on both sides.
2. Rotate upper handle to new catch desired.
FIG. 10
3. Re-tighten lever A.
FIG. 11
LIFT & TURN TO
DESIRED POSITION
LOCKING
LEVER
PUSH
TO
LOCK
LOCKING
LEVER
REAR DEFLECTOR
The rear deflector, attached between the rear wheels
of your mower, is provided to minimize the possibility
that objects will be thrown out of the rear of the mower
into the operator's mowing position. If the deflector
becomes damaged, it should be replaced.
ENGINE
ENGINE SPEED
Your engine speed has been factory set. Do not
attempt to increase engine speed or it may result in
personal injury. If you believe that the engine is running
too fast or too slow, take your lawn mower to
an authorized service centre for repair and adjustment.
THROTTLE CONTROL
If it becomes necessary to adjust or replace the
throttle control, see the adjustment section of your
engine manual.
CARBURETTOR
The carburettor has been preset at the factory and
adjustment should not be necessary. However, minor
adjustment may be required to compensate for
differences in fuel, temperature, altitude or load.
The air filter must be assembled to the carburettor
when running engine - never run an engine without
an air-filter.
Best carburettor adjustment is obtained when fuel
tank is 1/4 full.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents